← All lessons

Getting started with linear static analysis

Set a goal, choose consistent units and boundary conditions, and check axial displacement by hand.

Start with the result you need

Decide whether you need tip displacement or local stress. For a slender bar in axial tension, a one-dimensional element that transmits axial force can represent axial displacement and stress. To find local stresses around a hole or joint, use elements and a mesh that can represent that geometry.

Set the units and boundary conditions

If length is in millimeters and force in newtons, use mm² for area and N/mm² for Young’s modulus. Before building the model, write down which directions the real supports restrain and where each load acts.

Estimate displacement, stress, and reaction

For a uniform, linearly elastic bar under a small axial deformation, stress is P/A and extension is PL/(EA). With L = 1,000 mm, A = 100 mm², E = 200,000 N/mm², and P = 1,000 N, the stress is 10 MPa and the extension is 0.05 mm. Static equilibrium gives an axial reaction of 1,000 N opposite the applied load. These are hand calculations for comparison.

Reference: Hexagon MSC Nastran documentation

Next lesson → Coordinates, degrees of freedom, and constraints