← All lessons

Coordinates, degrees of freedom, and constraints

Distinguish GRID CP from CD, check load coordinate systems, and identify the components to restrain.

Separate position coordinates from component directions

On GRID, CP specifies the coordinate system used to enter the position. CD defines the directions used for components such as grid displacements and constraints. A correct geometry display does not verify CD. Check the load coordinate system separately when the load entry specifies one.

Turn a support into restrained degrees of freedom

Components 1–3 are translations and 4–6 are rotations. Check the axes at the relevant grid point before using a component number. Too little restraint can leave rigid-body motion. Too much can suppress the deformation you intended to model.

Check deformation and reaction directions

If a tilted support should restrain only motion normal to its surface, first check that the chosen component points along the normal. After solving, check that the model can deform in the intended directions and that the reaction matches the support.

Reference: Hexagon MSC Nastran documentation

Next lesson → BDF structure and eight-character fields